The Bottle and The Spout!

IT'S DONE

So I just finished the Bottle...... It took me quite sometime to get right, the spout I found quite easy in comparison to the bottle. Overall the bottle was challenging and required quite a long time, but nothing  really stumped me. When doing lofts I learnt a valuable lesson, and that is MAKE SURE THE POINTS PIERCE THE LINES. I had to go back many a time as I forgot to put in the pierce relation.

When putting the Decal on the bottle I had a few issues with the label being projected on to both sides of the bottle. Refer to slack Katie was talking about using the split surface feature to stop this from happening. After review videos and previous posts I couldn't find anything relating to it, so after asking a fellow class mate from some help I resolved the issue. Under Curves in the tools tab there is a feature called split surface. Simple to use, I simply split the surface and resolve the issue.

Here is what the back looked like before I resolve the issue: